✐ Up to 99,999 hours can be set for the time setting.
✐ If condition "When Auto Play is failed" is checked, the trap is sent when the error occurs during the auto display
operation using with the network viewer function (+p.109). For further information of the error, refer to item "Auto
Display setting and control page [3]"((+p.123).
Trap option
Trap option setting
Tick the check boxes in front of the condition item to send the trap.
✐ Click Set button if you tick or un-tick the check box on a page.
[1]––––––––––––––––––––––––––––––––––
o
When PJ lamp is off.
o When PJ lamp replacement time is reached.
o When internal PJ power circuit is failed.
o When internal PJ temperature is too high.
[2]––––––––––––––––––––––––––––––––––
o When PJ is turned into Standby in proper user
operation.
o When accumulated filter use time
reaches [ ] hours.
o When Power management function turns PJ
lamp off.
[3]––––––––––––––––––––––––––––––––––
o
When the signal is interrupted.
o When Auto Play is failed.
o When lamp Corres. Value
reaches [ ] hours.
SNMP setting
To Next Page
Loading...
Need help?
General