Sanyo PLC-XU116

32
Chapter 4 Wired LAN configurations
The Network PIN code is to restrict the access from the networks to the projector.
After setting the Network PIN code, you need to enter it to operate the projector via the networks.
Network PIN code
Network information
1. Select "Network PIN code" in the Network menu, and press SELECT button.
The Network PIN code screen will appear.
2. Set the Network PIN code.
Set the figures with the Point 54 buttons and move to the next items with the Point buttons.
Select “Set” and press SELECT button to set. To cancel the preset Network PIN code, select “Cancel”.
When you do not want to set the Network PIN code, set 0000.
It is recommended to set the Network PIN code if you use the projector via the networks. The Network
PIN code can be set also through the networks. See “6. Basic setting and operation”  “Initial setting”
“Network PIN code setting” (p53).
Select "Network information" in the Network menu and press Point  or SELECT button to show LAN
setting environment of the currently selected projector. (The description below is an example and
different from what will be shown.)
Network PIN code
Network PIN code screen