5
Entering the memory viewer mode
In case of already USB thumb drive is inserted into the USB port on the rear terminal of the projector
and you want to enter the memory viewer mode again:
1. Select Input in the main-menu, press Point or SELECT buttons, select Network in the sub-menu,
and then press SELECT button, or press NETWORK button on the remote control.
* After short time, the network connection standby display screen "Ready for use" will appear.
2. Select Network in the main-menu and then press SELECT button.
3. Select Memory viewer with Point 54 buttons and press SELECT button.
4. Select Start and press SELECT button. The image file stored in the root directory of the USB thumb
drive is displayed on the screen.
* If the image file is not available in the root directory of the USB thumb drive, the memory viewer
browser window appears.
To Next Page
Loading...
