57
Configuring wireless LAN setting and security setting
Configure the wireless LAN setting and security setting for Wireless 4 and Wireless 5.
Configuring wireless LAN setting
1. Click page [2] of setting pages. Following wireless LAN setting can be done. After completing the
configuration, press Set button.
Item Description
Wireless Mode ........Select the Communication standard 802.11b, 802.11b/g or 802.11b/g/n.
Network Type..........Select either “Infrastructure” or “AdHoc”. When selecting the "AdHoc", the
security "WPA-PSK" and "WPA2-PSK" mode are not available.
SSID/ESSID ...............Set the SSID/ESSID. (up to ASCII 32 characters)
SSID/ESSID is case-sensitive. Even though all characters on the Wireless
information is uppercase, it is necessary to distinguish between upper case and
lower case characters.
Channel.....................If you use the projector in 802.11AdHoc mode, select the channel, from 1 to 11.
Configuring wireless LAN setting and security setting
Notes for entering characters:
The “¥” symbol is displayed as “\” when the ASCII key is used. The “=” symbol is treated as a character
by the ASCII key, but it is not interpreted as a character by the HEX key. In HEX, the “=” symbol is
displayed in red and setting is denied.
You can not set all the characters with the “=” symbol. It will be considered as no operation.
ASCII key characters : Space - 0 to 9 A to Z a to z ! " # $ % & ' ( ) * + , . / : ; < = > ? @ [ ¥ ] ^ _ ` { | } ~
HEX key characters : 0 to 9 a to f
To Next Page
Loading...
