68
Chapter 7 Controlling the projector
Power control and status check
Click Power & Status on the main menu. The control page will be displayed.
By clicking ON or Standby button on the page, the power of the projector can be
controlled.
Item Description
PJ status
Power ............................Displays the status of the lamp. (ON, OFF, On starting up, On cooling down)
Status ............................Displays the status of the projector's power. (Refer to next page.)
Power control..............Controls the projector power by clicking the "ON" or "Standby" button.
PJ temp.
Inside temp.A .............Displays the surrounding temperature of lamp in the projector.
Inside temp.B .............Displays the surrounding temperature of panel in the projector.
External temp. ............Displays the surrounding temperature of the intake vent.
..........The warning icon will appear if the temperature exceeds a specified value. Check if there
is no object to obstruct the airflow around the intake or exhaust vent. It might be airfilter
clogged. Clean up the airfilter.
* The temperature unit can be set either Centigrade or Fahrenheit in the item "Initial
Setting". (p.54)
Popup confirmation window
Confirmation window as
shown in the below appears
when the Standby button is
pressed.
The projector cannot be turned on while the projector is cooling down.
The web browser checks and updates the projector's condition every 30 seconds automatically.
To Next Page
Loading...
Need help?
General
