Sanyo PLC-XU116

55
Network configuration
Click Network on the main menu. The following setting page is displayed. Set up the
projector's network environment on this Setting sub menu.
Setting of LAN
1. Select a type of LAN from Change setting pull down menu.
LAN1(Wired)
LAN2(Wired)
LAN3(Wired)
LAN4(Wireless)
LAN5(Wireless)
Simple(Wireless)
USB display
*
1
For the default setting of the above LAN, see the items "Wired Factory Default Setting" or "Wireless
Factory Default Setting".
*1 When selecting "Mouse control" in "USB terminal" from the setting menu, "USB display" cannot be selected.
*2 Set [255.255.255.255] if the network does not provide the gateway (router).
*3 Set [255.255.255.255] if you do not use the function E-mail alert.
Item Description
Change setting.......Selects LAN1 to LAN5 and Simple
DHCP..........................Sets DHCP configuration (ON/OFF)
IP address.................Sets IP address of the projector
Subnet mask............Sets Subnet mask.
Default gateway*
2
...........Sets IP address of the default gateway (Router)
DNS*
3
..........................Sets IP address of the DNS server.
Network configuration