EasyManuals Logo

Sanyo PLC-XU116 User Manual

Sanyo PLC-XU116
399 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #390 background imageLoading...
Page #390 background image
3
Inserting the USB thumb drive
USB thumb drive
Insert the USB thumb drive into the USB port on the rear terminal of the projector as shown in the
figure below.
USB port (Series A)
CAUTION on Handling and Storing the USB thumb drive
- Do not put USB thumb drive or its cap within close reach of children. Swallowing them may
cause suffocation.
- If the smoke or questionable odor rise, turn off the peripheral equipment and contact your
dealer.
- Do not put water, chemical or oil to the USB thumb drive. It may cause short out or fire.
- Do not put foreign objects or put metal objects to the USB terminal. Static electricity may cause
data loss or data corruption.
- Do not remove the USB thumb drive from the computer or the projector while the USB thumb
drive is reading out or writing the data. It may cause data loss or data corruption.
- Do not store the USB thumb drive where high temperature, humid or dusty place or magnetized
items are around.
Note:
When inserting, confirm the direction
of the plug not to damage the terminal.
USB thumb drive for the Memory Viewer function
Commercially available USB thumb drives or the supplied one for Auto Capture with this projector can
be used for this Memory Viewer function.
The USB port is compatible with USB thumb drive formatted with FAT16 or FAT32.
It is not compatible with other formats. Please note that when you format the USB thumb drive.
CAUTION on insertion and removal of the USB thumb drive
Please note following points to insert and remove the USB thumb drive.
- The indicator of the USB thumb drive will be blinking when it is inserted to the projector or while the
projector is reading out the data. Do not remove the USB thumb drive while it is blinking.
- When using a USB thumb drive without indicator, you cannot recognize when the projector reading
out the data. Please remove it from the projector after closing the memory viewer function or turning
off the projector.
- Do not install and remove the USB thumb drive frequently. Remove the USB thumb drive at least 5
seconds after installation. And install at least 5 seconds after removal. While installing or removing the
USB thumb drive, the projector is in switching period for those operation.

Table of Contents

Other manuals for Sanyo PLC-XU116

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-XU116 and is the answer not in the manual?

Sanyo PLC-XU116 Specifications

General IconGeneral
BrandSanyo
ModelPLC-XU116
CategoryProjector
LanguageEnglish

Related product manuals