100
Chapter 9 Appendix
Use of telnet
You can control the projector by using the telnet application
*1
installed on your computer. Normally,
the telnet application is available on your computer.
* The telnet 10000 port is used to control the projector.
Control
(For example, in case of using the telnet application of Mac OS X v 10.4)
1. Select Terminal from Applications -->Utilities. Type as below on the displayed window.
> telnet [return]
2. The telnet application will start and the following window will be displayed.
3. Type as below to connect the projector.
> open_172.21.99.251_10000 [return]
* Use the IP address assigned to the projector
4. When communication is established correctly, the word "PASSWORD:" appears on the window.
Type the login password (Network PIN code
*2
) for the projector and then press "Enter" key on the
keyboard. If you do not set up the Network PIN code, just press "Enter" key.
When the word "Hello" is replied, login has been succeeded.
* The password "1234" is used for the example.
To Next Page
Loading...
