-60-
Check the indicators for projector condition.
• • • green.
• • • red • • • off
• • • blinks green.
Q When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. When
this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lamp replace-
ment counter after replacement of the lamp.
Indicators and Projector Condition
• • • blinks red.
Troubleshooting
Indicators
Projector Condition
POWER
red/green
WARNING
red
LAMP
REPLACE
yellow
The projector is off. (The AC power cord is unplugged.)
Q
The projector is preparing for stand-by or the projection lamp is
being cooled down. The projector cannot be turned on until cool-
ing is completed and the POWER indicator stops blinking.
Q
The projector is ready to be turned on with the POWER ON-OFF
button.
Q
The projector is operating normally.
Q
The projector is in the Power management mode.
Q
The temperature inside the projector is abnormally high. The pro-
jector cannot be turned on. When the projector is cooled down
enough and the temperature returns to normal, the POWER indi-
cator emits a red light and the projector can be turned on. (The
WARNING indicator keeps blinking.) Check and clean the air fil-
ter.
Q
The projector has been cooled down enough and the temperature
returns to normal. When turning on the projector, the WARNING
indicator stops blinking. Check and clean the air filter.
Q
The projector detects an abnormal condition and cannot be turned
on. Check power supply circuit and fans control circuit.
To Next Page
Loading...
Need help?
General
