Care and Cleaning
1. For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
2. Do not pour water on the indoor unit to clean it. This will damage
the internal components and cause an electric shock hazard.
Casing and Grille
(Indoor Unit)
Clean the casing and grille of the indoor unit with a vacuum cleaner
brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild liquid
detergent. When cleaning the grille, be careful not to force the vanes out
of place.
CAUTION
1. Never use solvents, or harsh chemicals when cleaning the indoor
unit. Do not wipe the plastic casing using very hot water.
2. Some metal edges and the fins are sharp and may cause injury if
handled improperly; be especially careful when you clean these
parts.
3. The internal coil and other components of the outdoor unit must
be cleaned every year. Consult your dealer or service center.
Anti-Mold Filter The anti-mold filter behind the air intake grille should be checked and
cleaned at least once every two weeks.
How to remove the
anti-mold filter
1. Grasp both ends of
the air intake grille
and pull it out and
up.
2. Push the anti-mold
filter up slightly, and
then pull
it down.
Cleaning
•
The filter lamp turns orange to indicate that the air filter needs to be
cleaned soon. Clean the air filter when the lamp turns red. The lamp
turns on only for three seconds when operation starts. Be sure to
always press the FILTER RESET button after cleaning the filter.
•
Use a vacuum cleaner to remove light dust. If there is sticky dust on
the filter, wash the filter in lukewarm, soapy water, rinse it in clean
water, and dry it.
Air intake grille
Anti-mold filter
32 OI-275-32EG
OI275000
To Next Page
Loading...
Need help?
General
