If you wish to edit or dub your camcorder (or another VCR) recordings to this VCR, the rear
(or Front)
panel mounted Audio and Video
(AN)
input jacks make the connections quick and
easy. The direct
AN
jacks will also provide better picture results than using the
RF
jack
on
the
rear
panel.
Another VCR: Play
I
f (
II
II
)
o
oo\
cj>o
•
From
AUDIO and
VIDEO Output
: OR
·········~------------'
To AUDIONIDEO Input
~
....
..,
1 Connect the camcorder's (or another VCR's)
AN
outputs to your VCR as illustrated above.
2 Set the input channel "LINE2". (Press INPUT to select LINE2.)
•
If
you have connected your VCR to the
AN
input jacks
on
the rear of VCR, you should
select
the input channel
LINE1
by pressing INPUT twice.
3 Play the tape
in
the camcorder (or another VCR).
If
you have a TV attached to your VCR,
you can see the video
playing.
4 When you desire recording to begin, press VCR's REC once to start.
;NOTE
Before recording, please confirm the recording start position.
35
To Next Page
Loading...
Need help?
General
