Sartorius Basicplus - Page 28

28
* = not used on balances verified for legal metrology
** = only for balance verified for legal metrology
3 6 Display Parameter for Readouts in Percent
3 6 1 Without a decimal place
3 6 2 With one decimal place
3 6 3 With two decimal places
3 6 4 With three decimal places
3 7 Delay start until...
3 7 1 Difference is slight
3 7 2 Difference is average
3 7 3 Difference is considerable
3 8 Animal weighing/averaging will start by:
3 8 1 Manual mode
3 8 2 Automatic mode
5 Interface Port
5 1 Baud rate
5 1 1 150 baud
5 1 2 300 baud
5 1 3 600 baud
5 1 4 1200 baud
5 1 5 2400 baud
5 1 6 4800 baud
5 1 7 9600 baud
5 1 8 19200 baud
5 2 Parity
5 2 1 Mark *
5 2 2 Space *
523 Odd
5 2 4 Even
5 3 Number of Stop Bits
5 3 1 1 stop bit
5 3 2 2 stop bits
5 4 Handshake Mode
5 4 1 Software handshake
5 4 2 Hardw. handshake, 2 char.after CTS
5 4 3 Hardw. handshake,1 char. after CTS
6 Utilities for Printouts or Data Transfer
6 1 Data Output Parameter
6 1 1 Print on request regardless of stability
6 1 2 Print on request after stability
6 1 3 Auto print regardless of stability
6 1 4 Auto print regardless of stability
6 1 5 Auto print at stability
6 2 Auto Print
6 2 1 Start/stop auto print using the print key
6 2 2 Auto print not stoppable
6 3 Data Output at Defined Intervals
6 3 1 1 display update
6 3 2 2 display updates
6 4 Automatic Taring after Data Output
641 Off
642 On
7 Additional Functions
7 1 Print Application Parameter
711 On
712 Off
7 2 Print Format
7 2 1 Without data ID code
7 2 2 With data ID code
7 3 Auto Print Tare Memory 2 Data
7 3 1 Individual value N1
7 3 2 Total T1
8 Additional Functions
8 1 *Menu Access Function
8 1 1 Accessible
8 1 2 Depends on the setting of the menu
access switch
8 3 Key Functions
8 3 1 Accessible
8 3 2 Blocked
8 4 Universal Switch for Remote Control
841 p
842 t
843 q
844 v
845 c
8 5 Power-On Mode
8 5 1 (Power) off–> on <–> standby
8 5 3 On<–> standby
8 10 GLP/GMP-compliant Printout
8 10 1 No ISO/GLP printout or record
8 10 2 Only for calibration / adjustment
8 10 3 All printouts GLP-compliant
9 Reset Menu
9– –1 On
9 – –2 Off