6
bp-r1-d.tif
bp-a-03a.tif
bp-a-04a.tif
bp-a-02a.tif
Balance Operating Menu
Accessing and Setting the Balance Operating Menu
Accessing the Menu with the e and t keys:
– Turn the balance off and back on again by pressing e
– While all segments are displayed (“Segment Test”), briefly press t
– “1” is displayed
Note:
If “ –1” is displayed, this indicates that the operating menu is blocked by the
menu access switch.
The menu access switch is located on the rear panel of the balance (see
figure on the left).
To unlock the menu to change the menu code settings, move the switch to the
right.
Move the switch back to the left after you have made your menu code
settings !
Selecting a Code Setting using the q and the p Keys:
– Press q to select the desired number. Numbers increase by one with
each press and go from 9 back to 1 again (1, 2, 3 ... 8, 9, 1 ...).
– Press p to move from the first code number to the second and third
numbers (1st - 2nd - 3rd - 1st, etc.).
Changing and Storing a Setting with the t Key:
– Briefly press the t key to confirm the new setting. A “°” appears after
the new setting, e.g., “3-1-3 °".
– To store the setting, press one of the t keys for more than two seconds.
bp-a-01a.tif
Menu Access
Switch
Back Panel
To Next Page
Loading...
