To Next Page

To Previous Page

Operating Instructions Cubis

MCA 65

System Settings

Parameter Setting Values Explanation

Available units The availability of units may depend on national legislation and

istherefore country-specific. Multiple selection is possible.

mg – milligrams The device displays the weight in milligrams.

g – grams* The device displays the weight in grams.

kg – kilograms The device displays the weight in kilograms.

ct – carats The device displays the weight in carats.

oz – ounces The device displays the weight in ounces.

lb – pounds The device displays the weight in pounds.

ozt – troy ounces The device displays the weight in troy ounces.

tlh – Hong Kong taels The device displays the weight in taels (HongKong).

tls – Singapore taels The device displays the weight in taels (Singapore).

tlt – Taiwanese taels The device displays the weight in taels (Taiwan).

tlc – Chinese taels The device displays the weight in taels (China).

GN – grain The device displays the weight in grains.

dwt – pennyweight The device displays the weight in pennyweights.

mom – mommes The device displays the weight in mommes.

tol – tolas The device displays the weight in tolas.

bat – baht The device displays the weight in baht.

MS – mesghals The device displays the weight in mesghals.

N – newtons The device displays the weight in newtons.

Available

resolutions

All digits on* “All digits on”: All digits are shown in the display. Not available

onconformity-assessed devices.

Last digit off

atloadchange

“Reduced by 1 digit for load change”: The last digit on the display

is switched off until stability is achieved.

Last digit scale interval 1 “Last digit scale interval 1”: The last digit always shows

scaleinterval 1.

Last digit off “Last digit off”: The last digit is switched off.

Profile name User input Saves a name assigned for the weighing profile,

e.g.“My Weighing”.

Profile description User input Saves a description for the weighing profile entered (optional).

*Factory setting for the “Standard Weighing” factory-set weighing profile

Sartorius Cubis MCA225P Series User Manual

Questions and Answers: