Sartorius Cubis MCA225P Series - Cleaning the Device

Operating Instructions Cubis
®
MCA 97
Cleaning and Maintenance
t Remove the weighing pan and all associated components from
theweighing compartment, e.g. shield plate, pan support.
9.2 Preparing a Device with a Frame DraftShield
Procedure
t Turn the device off.
t Disconnect the device from the power supply. To do so, disconnect
thepower supply cable from the wall outlet.
t Remove the frame draft shield (1) and clean it with a brush or a damp
cleaning cloth.
t Remove the weighing pan (2).
t Remove the shield plate (3) and pan support (4).
9.3 Cleaning the Device
NOTICE
Corrosion or damage to the device due to unsuitable cleaning agents
t Do not use corrosive, chloride-containing, or aggressive cleaning agents.
t Do not use cleaning agents that contain abrasive ingredients,
e.g.scouring agents, steel wool.
t Do not use solvent-based cleaning agents.
t Check whether the cleaning agents used are compliant materials
(seeChapter “15.4 Materials”, page 109).
t Make sure that cleaning materials, such as cloths, are only slightly damp.
1
2
3
4