Sartorius SIWRDCP - Key Functions and Device Parameters; FN Key Assignment; Weighing Platform 1 Device Parameters

Signum 1-2-3
Settings
25
fn-key Key assignment k
OFF * k key
gronet Signum
®
1 only: Gross/Net toggling
2. unit Display of 2nd weight unit
res 10 Signum
®
1 only: 10-fold increased resolution, display max. 5 seconds
sqmin Display the minimum permissible sample quantity
3
)
Setup Device Parameters
A password prompt is displayed if a password is configured
wp-1
1
Weighing platform 1
(Display designation of this menu level: 1 )
1.1. Adapting the scale to ambient conditions (filter adjustment)
1.1.1 Very stable conditions
1.1.2 * Stable conditions
1.1.3 Unstable conditions
1.1.4 Very unstable conditions
1.2. Application filter
1.2.1 * Final readout
1.2.2 Filling mode
1.2.3 Low filtering
1.2.4 Without filtering
1.3. Stability range
1.3.1 4 digit
1.3.2
4
) 1 digit
1.3.3 1 digit
1
)
1.3.4 * 2 digits
1
)
1.3.5 4 digits
1
)
1.3.6 8 digits
1
)
1.4. Stability delay
1.4.1 Without delay
1.4.2 * Short delay
1.4.3 Average delay
1.4.4 Long delay
1.5. Taring
1
)
1.5.1 Without stability
1.5.2 * At stability
1.6. Auto zero
1.6.1 * On
1.6.2 Off
1.7. Weight unit 1
2
)
1.7.1 Grams /o
1
)
1.7.2 * Grams /g
1.7.3 Kilograms /kg
1.7.4 Carats /ct
1
)
1.7.5 Pounds /lb
1
)
1.7.6 Ounces /oz
1
)
1.7.7 Troy ounces /ozt
1
)
1.7.8 Hong Kong taels /tlh
1
)
1.7.9 Singapore taels /tls
1
)
1.7.10 Taiwan taels /tlt
1
)
1.7.11 Grains /GN 1)
1.7.12 Pennyweights /dwt
1
)
1.7.14 Parts per pound /lb
1
)
1.7.15 Chinese taels /tlc
1
)
1.7.16 Mommes /mom
1
)
1.7.17 Austrian carats /K
1
)
1.7.18 Tola /tol
1
)
1.7.19 Baht /bat
1
)
1.7.20 Mesghal /MS
1
)
1.7.21 Tons /t
1
)
1.7.22 Pound: Ounces
1
)
1.8. Display accuracy 1
1
)
1.8.1 * All digits
1.8.2 Reduced by 1 decimal place for load change
1.8.14 10-fold increased resolution
1.8.15 Increase resolution by 2 scale intervals
1.8.16 Increase resolution by 1 scale interval
1) = Not available on equipment verified for use in legal metrology
2) = Depends on weighing platform model
3) = Only active when minimum sample quality has been entered by Service and menu item: SQMIN: DISPLAY:ON
4) = Factory setting for use in legal metrology
Settings