Satel MICRA - Adding New Wireless Devices; Removing Wireless Devices

SATEL MICRA 11
3.8.1 ADDING NEW WIRELESS DEVICES
Wireless detectors
You can add the wireless devices in the "Options, zones, outputs" tab, "Wireless zones"
table:
1. Click your mouse pointer on one of the fields at the detector you want to add.
2. Click on the "New detector" button. The "New detector Zn" window will open, where
n means the zone number (Z6 – Z13).
3. According to the command displayed in the window, close and open the tamper contact of
the detector.
4. A message will be displayed in the window to confirm that the detector type and serial
number have been read. Click "OK". The window will close, and the data read will be
displayed in the corresponding fields.
5. Enter the detector name in the "Name" field.
6. Save the data to the module.
Wireless keypad
You can add the MKP-300 wireless keypad in the "MKP-300 keypad" tab:
1. Click on the "Register" button.
2. The "MKP-300 keypad" window will open, where the command to open the keypad tamper
contact will be displayed. When this action is completed, click "OK".
3. After receiving the transmission by the module, the keypad will be registered in the
system.
4. Save the data to the module.
3.8.2 REMOVING WIRELESS DEVICES
Wireless detectors
1. Select in the "Options, zones, outputs" tab, "Wireless zones" table, any field corresponding
to the required detector, and then click on the "Remove detector" button.
2. Save the changes made to the module.
Wireless keypad
1. Select the keypad serial number in the "MKP-300 keypad" tab, "Serial number" field, and
then delete it.
2. Save the changes made to the module.
4. PROGRAMMING AND CONFIGURING THE MODULE
For programming and configuring the module, the GPRS-SOFT program version 1.04.004 is
required. The program is delivered free of charge with the device. Communication between
the program and the module can be effected locally or remotely. The module with factory
default settings can only be programmed locally.
You can also program some module functions by means of SMS messages.
4.1 LOCAL PROGRAMMING THROUGH RS-232 (TTL) PORT
The serial COM port of the computer must be connected with the RS-232 (TTL) port on the
module electronics board. The cables for making this connection are available as a set
designated DB9FC/RJ-KPL. Indicate in the GPRS-S
OFT program the computer COM port to
be used for communication with the module. To do so, click on the "Configuration" button
(see: Fig. 8 and explanations for the figure) and, in the window that will open, select one of