Satel MICRA - Starting GPRS Reporting; Starting SMS Reporting

38 MICRA SATEL
– if the module users are to be authorized to remotely control the system by means of
SMS messages (arming/disarming, clearing alarms, bypassing/unbypassing zones,
controlling outputs), define the suitable control commands.
2. If the module is to be operated by means of keyfobs, click on the "Keyfobs" tab and add
the keyfobs (see: description of adding keyfobs, p. 33-33).
3. If the module is to be operated by means of the MKP-300 keypad, click on the "MKP-300
keypad" tab, register the device (see: Adding new wireless devices) and program it
accordingly (see: „MKP-300 keypad” tab).
4. Click on the "Reporting" tab and then enable the "Set CID codes automatically" option.
The codes will be automatically matched to corresponding events (see: description of the
"Set CID codes automatically" option, p. 30). Enabling the option is recommended not
only when event codes are to be sent to the monitoring station. The codes and their
descriptions are written to the event log, thus facilitating diagnostics.
5. If the module is to execute the reporting or messaging functions, configure suitable
parameters and options, as recommended in sections "
Starting GPRS reporting",
"
Starting SMS reporting" and "Starting CLIP / SMS messaging".
4.6 STARTING GPRS REPORTING
1. Enter the GPRS communication parameters ("GSM telephone, Monitoring stations" tab):
– Access Point Name (APN) for Internet GPRS connection;
– user name for Internet GPRS connection;
– password for Internet GPRS connection;
– DNS server IP address which is to be used by the module (the DNS server address
requires no programming, if the IP address is entered for the monitoring station).
– password initializing connection with the computer.
2. Configure parameters of the monitoring station(s) ("GSM telephone, Monitoring stations"
tab):
– select the "GPRS" option;
– enter the monitoring station address ("Address (GPRS)" field);
– enter the number of TCP port through which communication with the monitoring station
will be effected;
– enter the encryption key for data to be sent to the monitoring station (“Station key”);
– enter the GPRS key.
3. Indicate the monitoring station to which the event code is to be sent (the event may be
sent to both monitoring stations) and define the Contact ID codes for events to be
reported. It should be done in the "Reporting" tab, the "Keyfobs" tab ("Reporting" tab) and
in the "MKP-300 keypad" tab, "Messaging / reporting" table. In the alarm module mode,
with the "Set CID codes automatically" option enabled, the codes are assigned
automatically.
4.7 STARTING SMS REPORTING
1. Enter the telephone number of Short Message Service Center in "SMS center number"
field in the "GSM telephone, Monitoring stations" tab”, unless it has been saved by the
operator to the SIM card memory.
2. Configure parameters of the monitoring station(s) ("GSM telephone, Monitoring stations"
tab):
– select the "SMS" field;