22 MICRA SATEL
– disarming, if there was an alarm during the armed mode – 4 pulses.
SMS control
Control of the outputs by means of commands sent in SMS messages is possible in the
communication device mode and, for the CONTROLLED type outputs, in the alarm device
mode.
Turn on – content of the control command which will be used to activate the relay output.
Turn off – content of the control command which will be used to deactivate the relay
output.
Turn on for period – content of the control command which will be used to activate the
relay output for a period of time (the cut-off time must be defined for the output).
4.3.3 „GSM TELEPHONE, MONITORING STATIONS” TAB
Fig. 11. "GSM telephone, Monitoring stations" tab.
Programming
MICRA identifier – a sequence of 1 to 8 alphanumeric characters to identify the module.
Communication between the program and the module is only possible when the identifier
entered in this field is consistent with that stored in the module. No identifier is
preprogrammed in the module with factory default settings. Communication with such
a module can be established without entering any identifier in the program, but as soon as
the connection is established, the program will automatically generate a random identifier.
It can be saved into the module or enter another one and save it.
Remote programming – enable this option if remote programming of the module with the
use of GPRS technology is to be available.
To Next Page
Loading...
