Satel MICRA - Page 23

SATEL MICRA 21
SMS control (zones)
Bypass – content of the control command that must be included in the SMS message
being sent to the module for the zones to be bypassed (blocked). Depending on the
module operating mode:
communications device – all zones with the "Blocked" option enabled will be blocked.
alarm device – the zones specified in the received SMS message will be bypassed.
The SMS message should have the following form: xxxx=n= (where "xxxx" is the
command, defined in the "Bypass" field, starting the zone bypassing function in the
module; "n" is the number of zone to be bypassed – where two or more zones are to
be bypassed, they must be separated by commas and then the command should
have, for example, the following form: bypass=1,2,3= ). The zone will remain
bypassed until it is unbypassed by using the control command received in the SMS
message.
Unbypass – content of the control command that must be included in the SMS message
being sent to the module for the zones to be unbypassed (unblocked). Depending on
the module operating mode:
communications device – all blocked zones will be unblocked.
alarm device – zones specified in the received SMS message will be unbypassed. The
SMS message should have the following form: yyyy=n= (where "yyyy" is the
command, defined in the "Unbypass" field, starting the zone unbypassing function in
the module; "n" is the number of zone to be unbypassed – where two or more zones
are to be unbypassed, they must be separated by commas and then the command
should have, for example, the following form: unbypass=1,2,3= ).
Note: The armed zones cannot be bypassed / unbypassed (alarm device mode).
Output 1 / Output 2
Output type – parameter available in the alarm device mode. You can select one of the
following types:
Not used – the output is not used.
Burglary alarm – signaling alarms from the 0. I
NSTANT, 1. 24H and 4. DELAY zone types. It
is also activated in the event of panic alarm triggered from a keyfob (the "10: panic
alarm" function is assigned to the button). The alarm is being signaled during the output
cut-off time.
Burglary alarm latched – signaling alarms from the 0. I
NSTANT, 1. 24H and 4. DELAY zone
types. It is also activated in the event of panic alarm triggered from a keyfob (the "10:
panic alarm" function is assigned to the button). The alarm is being signaled until
cleared.
Arm status – active when armed mode is on.
Controlled – controlled by means of zones, keyfobs or SMS messages.
NC – if the option is enabled, the output will operate as the NC (normally closed) output.
When the option is disabled, the output will operate as the NO (normally open) output.
Output cut-off time – the time during which the output is to be active. The parameter is valid
when the output is activated for a period of time. If the output cut-off time is not
programmed, activating the output for a period of time will be impossible.
Arm/Disarm chirp – option available in the alarm device mode for the B
URGLARY ALARM and
B
URGLARY ALARM LATCHED zone types. The output signals the following states by means of
approx. 0.3 second pulses:
– arming – 1 pulse;
– disarming – 2 pulses;