Satel MICRA - Page 3

Changes made to firmware version 2.02
Power
The module can be powered with 12 V DC.
Clock
When logging into GSM network, the module automatically downloads
time and date information, if such a service is offered by the GSM
network operator.
Relay outputs
Capability of NC (normally closed) operating mode.
Ability to control outputs using the CLIP service.
Wireless
devices
Support for new wireless devices:
1. wireless detectors
– MSD-300 smoke and heat detector,
– MPD-300 passive infrared detector,
– MMD-300 magnetic contact.
2. MKP-300 wireless keypad.
3. MPT-300 keyfob.
Arming /
disarming
Capability of arming / disarming with the CLIP service.
Using the CLIP service or defined SMS message, the module can inform
about arming / disarming with the CLIP service.
SMS message
retransmission
The module can forward received SMS messages to the specified
telephone numbers, which makes it possible e.g. to transmit information
received from the operator of GSM network in which the module
operates.
Status
messaging
SMS message containing module status information has been
supplemented with:
– data on wireless zone status;
– information on exceeding the transmission limit.
Programming
Programmability of some module parameters by SMS messages.
Parameters and
options
Module with factory settings operates in the alarm device mode.
New option:
– A
LARM IF ZONE VIOLATED AT THE END OF EXIT DELAY.
New parameter:
– L
IMIT NUMBER OF NOTIFICATIONS TO.
GPRS-Soft
program
Order of program tabs has been changed.