SATEL MICRA 31
Fig. 14. „Reporting” tab for the alarm device mode.
Reporting parameters
Note: For the analog zones, the reporting related parameters are to be determined
separately for each of the defined thresholds.
S1 – select this field if the event code is to be sent to the monitoring station 1.
S2 – select this field if the event code is to be sent to the monitoring station 2.
Violation/pass / Restore
CODE – the event code in the Contact ID format that will be sent to the monitoring station.
For each event to be monitored, 4 digits should be programmed in the Q-XYZ form,
where:
– Q – digit 1 or 3 (1 – new event/disarming, 3 – new restore/arming),
To Next Page
Loading...
