Need help?Do you have a question about the SATO CL608e/CL612e and is the answer not in the manual?
General introduction to the CL608e/CL612e printers and the manual's scope.
Outlines technical specifications for print speed, resolution, media handling, and interfaces.
Explains configuration options via printer dip switches (DSW1, DSW2, DSW3).
Describes the printer's factory default configuration and restoration process.
How to navigate and configure printer settings via the LCD panel.
Basic printer settings like Print Darkness and Print Speed in Normal Mode.
Procedures for adjusting more advanced printer settings via the LCD panel.
Procedures for entering and using Service Mode for sensor calibration.
How to reset the printer to its original factory default configuration.
Procedures for counter clearing and firmware resetting in Maintenance Mode.
Introduces the section on printer interface specifications and connectivity options.
Lists and describes the various available interface modules for the printers.
Introduces chapter on electrical checks, voltage levels, and sensor adjustments.
Preparatory steps for accessing internal components for adjustments.
Guides checking DC voltage levels at test points using a multimeter.
Identifies potentiometers and their adjustment functions on PCB and front panel.
Adjusting print position using VR3 potentiometer on the front panel.
Adjusting print position using VR1 potentiometer on the main PCB.
Procedures for adjusting the label gap sensor using VR4 potentiometer.
Introduces mechanical adjustments for printer sub-assemblies.
Detailed steps for adjusting print head alignment using Allen screws.
Adjusting print head balance to prevent ribbon wrinkle.
Introduces the section on replacing printer components and sub-assemblies.
Step-by-step guide for removing and replacing the printer's main circuit board.
Detailed procedure for removing and replacing the printer's power supply unit.
Comprehensive guide for removing and installing a new print head.
Introduces Factory Reset Mode and its available functions.
Steps to reset printer to factory settings and perform a test print.
Instructions for clearing printer's EEPROM, resetting all settings.
Introduces troubleshooting section and outlines covered topics.
Preliminary checklist to perform before diagnosing printer issues.
Explains printer error signals, LED indicators, and buzzer codes.
Tables listing symptoms, causes, and corrective actions for print quality issues.
Steps to reset the printer to factory settings, often needed after installing options.
To Next Page
General
