Unit 3: Command Quick Reference
SATO GL4xxe SBPL Programming Reference Page 3-3
*a,bbb Clear Memory Card. Stores a label image in Expanded Memory.
a = Memory section to be cleared.
G: SATO graphics file (001 to 999)
P: PCX graphics file (001 to 999)
F: Stored formats (001 to 999)
O: TrueType fonts, memory card (001 to 009)
R: BMP graphic file (001 to 999)
bbb = BMP graphic file (001 to 999)
@,nn...n Offline/Pause. Signals the printer to go offline after upon job completion.
nn...n = Optional message to be displayed on the LCD (max 32
characters).
A3H-aaaa-Vbbbb Base Reference Point. Establishes a new base reference point position
for the current label. Units of measurement are dots.
- = Optional character.If included, will shift reference point in
negative direction.
aaaa = Horizontal reference point
bbbb = Vertical reference point
AX Print Area Enlargement. This command sets the printer to the Expanded
print length (14 inches). <ESC>EX0 is the recommended replacement.
COMMAND QUICK REFERENCE
INSTRUCTION DESCRIPTION
To Next Page
Loading...
