Unit 4: Standard Command Codes
SATO GL4xxe SBPL Programming Reference Page 4-54
CUT, LABEL
FUNCTION
Regulates label cutting when using a cutter assembly with the printer. This command
allows the cutting of a multi-part tag or label at a specified interval within a print job. It
differs from the <ESC>~ Cut Job command in that it does not interact with the
quantity command.
FORMAT
ESC>~Aaaaa
aaaa = Number of labels to print between each cut (1 to 9999)
Place preceding the <ESC>Q Print Quantity command.
EXAMPLE
This set of commands will print seven labels with two labels between each cut. One
label will be cut separately.
OUTPUT
(4-39)
NOTES
The optional cutter assembly must be installed and enabled to use this function.
If the cutter option has been enabled in the printer configuration and the cut value is
(a = 0), the cutter is inactive.
This command is independent of the <ESC>Q Quantity command. It will cut the
specified number of labels.
To Next Page
Loading...
