< Currents >
The above Menus shows Initial Set Up status. When a function or mode is selected by
pushing the function key on the Sub Menu (Keys F1~F4), the selected function or mode is
activated instantly, and then the POP UP window is shut off and the selected menu is
displayed on screen.
Help
While the Meter is in operation, pressing the key longer than 1 second will display
brief information or an explanation about the present function or mode.
Press the key longer than 1 second to exit Help mode.
Help mode contains brief information from the Users Manual for quick reference.
Where Help information is more than 1 page of the screen, you can scroll the contents with
Cursor (Up/down) keys.
Data Hold/Auto Hold
In order to momentarily hold the measurement value on the screen, press HOLD
key. The measurement value is displayed in Holding mode, but the meter is actually still
acquiring measurement data. Pressing the key once more will release HOLD
mode.
Pressing for more than 1 second will enter Auto Hold mode. When in Auto Hold
mode, the monitoring and display of the input signal is continuously updated.
Whenever a new measurement is acquired during Input the display is updated and the alert
signal sounds.
Auto Hold can be reset by pressing the key.
Hold the key for longer than 2 seconds to release Auto Hold.
To Next Page
Loading...