Measurement Range selection (Auto/Range)
Selected Measurement Range is shown to the Right of the BAR-GRAPH. The key,
changes between AUTO Range mode or Manual Range mode. Pressing the key in
MANUAL Range mode will automatically shift the meter back to AUTO Range.
[NOTE]
Key is not active during Capacitance, Diode, or Frequency modes which are always
set automatically Auto Ranging.
Manual Range mode can be switched to Auto Range mode by holding the key longer
than 2 sec.
Auto Range mode can be switched to Manual Range mode by holding the key
longer than 2 sec.
In manual mode, the Up/Down keys will move the decimal point for the range.
[Multi-meter Sub Menu]
<Volts>
< Resistance, Diode, Capacitance>
To Next Page
Loading...