SBS 600 - Peak Hold

47
 Factory Default settings / Options
Function
Initial
Set Up
Setup Options
Back Light
ON
ON(10minute), OFF
Auto Power
OFF
ONOFF, 5m ~ 240minute
LCD Contrast
50
30 ~ 70 Adjust
Key Sound
ON
ON, OFF
Beep Sound
ON
ON, OFF
Auto hold Threshold
4%
1%~30%
Recording Threshold
4%
1%~30%
㏈ Reference
600Ω
2, 4, 6, ..............1200
Calibration
OFF
ON, OFF
Update Firmware
Device Information
USB Interface
OFF
ON, OFF
Help Language
English
English
 Initial Impedance Set Up for ㏈m measurement
Impedance to measure ㏈m can be set up within the range of 1 ~ 1200Ω.
Factory preset value is 600 Ω.
 Be
ep(Buzzer) Sound Set Up
 This mode controls the sound during Continuity Test.
 This mode can is set to ON or OFF in the User Menu.
[T
he WARNING sounds for input Over Voltage or battery power low warnings are set up with
the "TONE" setting which is a different set up procedure than the above Continuity sound.]
 Key Sound(MUTE)
 This mode toggles the Function key sound when Pressing “Function” keys.
 This mode can is set to ON or OFF in the User Menu.
 Auto Power Off
 U
ser can select the APO(Auto Power Off) time in the range from 10minute~60 minutes
 User can select 10, 15, 20, 30, 45, 60min, or OFF.
 With the APO timer active, the Meter will be automatically Powered off after the set amount
of time unless any of following events occur.
 Pressing any function key or menu key.
 Change of measurement function.
 Data Logging is Active
 Peak Hold is Active
 APO is disabled in the User Menu.
 To turn the meter on from APO after Power is Off, press any key on the meter.
 To disable APO function, select OFF in the User Menu.