Read the Users Manual prior to using the Meter
Pay special attention to the “Safety Precautions” section of the manual.
Attention
Attention mark may be displayed while meter is in use. Meter can be damaged or
important Data may be lost if the Meter is not properly used.
Warning
Warning mark may be displayed while meter is in use, using the meter on voltages above
safety ratings may cause serious personal injury or fatal death.
[Safety Symbol]
Table lists and describes the safety symbols shown on the Meter Display or in the User
Manual.
: DC (Direct Current or Voltage) : AC (Alternating Current or Voltage)
: DC and AC : Earth Ground
: Double Insulation
: Power Supply OFF : Power Supply ON
: Warning on Electric Shock : Warning on Danger
: CategoryⅡ 1000V Overload Protection
: CategoryⅢ 600V Overload Protection
[Notes for Safe Operation]
WARNING: USE EXTREME CAUTION IN THE OPERATION OF THE METER
Improper use of the Meter can result in injury or death.
Follow all safeguards in this manual, in addition to the normal safety precaution used in
working with electrical circuits.
DO NOT SERVICE the Meter if you are not qualified to do so.
[ WARNING ]
Pay attention when testing conditions exceeded 60V DC, 30V AC rms or 42.4V AC Peak
that can cause electrical shock. Do not connect the ground wire to a voltage higher than 0V
DC, 30V AC rms or 42.4V AC Peak.
Use only the accessories supplied with the Meter. Rechargeable Battery Pack, AC
Power Adapter and Internal Charger, Test Leads, Probes, Logic/Signal Cable set.
Warranty will not cover Meter Measurement failure or damage from improper accessories
other than those supplied by the manufacturer with the Meter.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
To Next Page
Loading...