Connect and disconnect properly. Test leads, Probes or Test Cables must always be
connected to the meter before connecting into circuits to be measured. Always remove leads
from test circuit prior to disconnecting from the meter.
Meters with rechargeable NiMH battery packs must only use manufacturer supplied
replacement batteries. Remove the AC Power Adapter, Test Leads, Probes and Cables
from the Meter when replace the Battery.
When the Battery Warning Symbol is blinking on the display, the measured values may be in
error. Replace with new batteries or recharge the unit.
Observe all input terminal ratings. Observe all ratings and markings on the Meter. Refer to
the users manual for detailed information.
[ Max Input Voltage]
- Meter Input: 600V CATⅢ.
Do not apply voltage when measuring in the Ohm(resistance) or Capacitance Meter Mode.
Do not use the meter in or near explosive, flammable, wet or damp environments.
Do not use Meter if the Case Cover is opened for any reason.
Fuses must be replaced with only the proper size and rating as the original.
Do not expose internal circuits.
[ATTENTION]
Before testing for Resistance, Capacitance. Continuity or Diode, disconnect any power
supply at the circuit being tested and discharge High Voltage Rated Capacitors.
Do not attempt Voltage measurements while measuring Currents.
[ENVIRONMENT]
The Meter is designed Indoor use in the following environmental conditions:
Operating Temperature: 0°C ~ 50°C
Guaranteed Accuracy Temperature: 23 0°C +/- 5°C
Operating Humidity: 80% R.H. or less
Storage Temperature: 0°C ~ 70°C
Altitude : 2000m
Pollution Degree: 2
WEEE (Waste Electrical and Electronic Equipment) (2002/96/EC)
Meter complies to WEEE (2002/96/EC) requirements.
Do not dispose Electrical / Electronic devices with other trash.
To Next Page
Loading...