[Menu - Active Logging]
[Menu - Logging Review]
[How to Operate]
First: Select ”Voltage”, Current, Resistance, Capacitance or AUX” from the Main Menu.
Second: press “Logger” key to enter Data Logging function.
Set “F1” Sampling rate and “F2” RUN time in sub menu.
After set up, press “F3” (Start) key to start Data Logging.
Data Logging is to achieve measured data for the desired time period. To minimize error
during Data Logging, all keys (except Power On/Off key, Data Logger Sub Menu keys) are
disabled during Data logging.
While the Data Logger is running after set up, Automatic Power Off function is also
de-activated.
To stop Data Logger function when Data Logger in running, press the “F4” (Stop) key in the
Sub Menu.
[Note]
Data Logging stops when
Data Logging (Running) preset time is over.
Data Logging data exceeds the Internal Memory Capacity.
Battery Drains completely when Battery is the only power supply.
1) Data Logger Set Up
Factory defaults below will be used if not changed during logging setup.
Sampling Time : 1s
RUN Time : 10,000s
Max Sample Data : 10,000 records
[Menu Logging Setup]
To Next Page
Loading...