83
SCClub operating instructions
Care
* Use one hand to reach under the brewing unit into
the shaft, undo the lock and hold (Figure 1)
* Slowly lead the brewing unit all the way down, tip it
and remove it towards the front
* Remove the brewing unit and hold on tight while
doing so
Use the multi-tool from the accessories.
* Turn the thread on the head of the brewing unit
anticlockwise (Figure 2) until the ejector is located
in the front position.
* Carefully pull the springs outwards and press them
down
This unlocks the insertion chute.
* Fold the insertion chute [1] upwards
* Clean the brewing sieve under running water or
with a cloth
* Remove ground coee residues with a brush
* Rinse the brewing unit under running water
Possible damage
• The brewing unit can get damaged by
cleaning products or in the dishwasher
> Use only water to clean the brewing unit
> Never clean the brewing unit in the
dishwasher
Figure 1
Figure 2
1
Figure 3
IMPORTANT
Observe the Warranty chapter
w from page 106