Schaerer Coffee Club - Page 84

84
SCClub operating instructions
Care
* Dry o󰀨 the brewing unit with a cloth
Let it dry completely before installing it into the co󰀨ee
machine
Remove ground co󰀨ee residue in the shaft
* Wipe out the ground co󰀨ee towards the front or
use a hoover
* Insert the springs into the insertion chute (Figure 4)
Pay attention to the guides.
Reinstall the dry brewing unit.
Turn the thread on the head of the brewing unit
anticlockwise (Figure 2) until the scraper is once
again
completely folded in
* Press and hold down the lock and place the
brewing unit into the shaft all the way to the back
on the rear wall
* Push the brewing unit upwards vertically until the
lock engages
* Insert the grounds container.
* Insert the drip tray
If the brewing unit cannot be inserted without
resistance:
> Turn the thread on the head of the brewing
unit a bit to the left or right with the multi-tool
until the brewing unit slides into the guides.
> Never use force! Risk of breakage.
Figure 4
Brewing sieve
IMPORTANT
Observe the Warranty chapter
w from page 106