www.scheppach.com
GB
|
29
were instructed concerning the operation of the ma-
chine and who are informed about the associated dan-
gers. The minimum age requirement must be complied
with.
-
served.
arise due to non-observance of these instructions and
2. Device description (g. 1 - 4)
1. Saw bench
2. Bench insert
3. Saw blade
4. Saw blade guard
5. Suction hose
6. Riving knife
7. Transverse stop
8. Bench extension
9. Push stick
10. Underframe
11.
11a. Overload switch
12. Hand wheel
13. Locking handle
14. Guide rail
15. Rip fence
16. Legs
16a. Rubber feet
16b. Support frame
17. Long crossbar
18. Short crossbar
19. Hexagon head bolt
20. Hexagon head nut
21a. Support strut long
21b. Support strut short
21c. Cross member
22a. Ring spanner 10/21 mm
22b. Ring spanner 10/13 mm
3. Unpacking
• Open the packaging and remove the device care-
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
success.
Note:
product that occurs due to:
• Improper handling
• Non-compliance of the operating instructions
•
technicians
• Installation and replacement of non-original spare
parts
•
•
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113
Please observe the following:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the user
to become familiar with the machine and take advan-
tage of its application possibilities in accordance with
the recommendations.
The operating instructions contain important informa-
-
-
and service life of the machine.
-
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
To Next Page
Loading...
Need help?
General
Weight and Dimensions
