www.scheppach.com
GB
|
41
Please provide the following information in the event
•
•
•
15. Disposal and recycling
Notes for packaging
-
clable. Please dispose of packag-
manner.
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
• Used batteries or rechargeable batteries that are not
• Owners or users of electrical and electronic devices
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
•
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
-
and online), provided that dealers are obliged to
-
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
-
the manufacturers and distributors can be ob-
tained from the respective customer service.
the mains of at least 100 A per phase.
• -
-
ate the product meets one of the two requirements,
a) or b), named above.
Important information
In the event of an overloading the motor will switch
motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
not hang on the power network during the inspection.
-
cables with the marking „H05VV-F“.
AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
2
.
Connection type Y
If the mains connection cable of this device is dam-
avoid dangers.
To Next Page
Loading...
