www.scheppach.com
40
|
GB
- -
ton.
Service information
Please note that the following parts of this product are
parts are therefore also required for use as consum-
ables.
blade
* !
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
13. Storage
•
and frost-proof place that is inaccessible to children.
• The optimum storage temperature is between 5 and
• Store the electrical tool in its original packaging.
• Cover the electrical tool in order to protect it from
dust and moisture.
•
• Store the operating manual with the electrical tool.
14. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions.
The customer‘s mains connection as well as the
extension cable used must also comply with these
regulations.
• The product meets the requirements of EN 61000-
-
lectable connection point is not allowed.
•
-
•
points that
-
11. Transport
1.
2.
not touch the table extensions.
3. Protect the power tool from knocks, bumps and
strong vibrations, such as during transport in ve-
hicles.
4. Secure the power tool against overturning and
sliding.
5. -
porting purposes.
12. Maintenance
m Warning!
service work disconnect the mains power plug!
12.1 General maintenance measures
-
housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it down with
compressed air at low pressure.
- -
-
some soft soap. Do not use cleaning agents or sol-
in the equipment. Ensure that no water can get into
the interior of the equipment.
- In order to extend the service life of the tool, oil the
-
with compressed air.
12.2 Brush inspection
- In case of excessive sparking, have the carbon
-
portant. The carbon brushes should not be replaced
12.3 Overload switch
The device motor is protected against overload with an
overload switch (11a).
In the event of the nominal current being exceeded, the
If this happens, proceed as follows:
- Let the device cool down for several minutes.
- Press the overload switch (11a).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
