Scheppach HS100S User Manual

www.scheppach.com
42
|
GB
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer’s customer service for
this.
•       
and sold in the countries of the European Union
       
2012/19/EU. In countries outside the European Un-
󰀨
waste electrical and electronic equipment.
16. Troubleshooting
Problem Possible cause Help
Saw blade gets
loose after turning
󰀨
Fixing nut not tight enough 
Motor does not start
Mains fuse blown Check the mains fuse
Extension cable defect Replace the extension cable
Connections to the motor or switch
not OK

Motor or switch defective 

power, fuse tripping
Cross section of the extension cable
󰀩
See “Electrical Connection” in the operating
manual
Overload due to blunt saw blade Replace saw blade
Burn areas at the
cutting surface
Blunt saw blade Sharpen saw blade, replace
Wrong saw blade Replace saw blade

Scheppach HS100S Specifications

General

Blade bore	30 mm
Blade diameter	250 mm
Number of teeth	24
Idle speed (max)	5000 RPM
Cutting depth (90º)	-, 85 mm
Maximum cutting height	85 mm
Saw blade included	-
Height adjustment range	0 - 85 mm
Input power	2000 W
AC input voltage	220-240 V
AC input frequency	50 Hz

Weight and Dimensions

Depth	940 mm
Width	780 mm
Height	1100 mm
Weight	19400 g
Bench depth	485 mm
Bench width	642 mm