3. Start the engine with the pull starter (25). To do this,
pull the handle out approx. 10-15 cm (until resis-
tance is felt). And then pull hard with a jerk. If the
engine does not start, pull on the pull starter (25)
again.
4. Due to protective coating on the engine, a small
amount of smoke may be present during the initial
use of the product and should be considered nor-
mal. This is a normal process.
ATTENTION
– Do not allow the pull starter to recoil. This can re-
sult in damage.
– In case of cool weather, it may be necessary to
repeat the starting process numerous times.
11.5 Switching off the engine (Fig. 1,
21)
WARNING
Danger of injury!
After switching the engine off, the blade continues to
run for a few seconds. If you touch the rotating parts,
you may cut yourself.
– Wait until the blade comes to a standstill.
– Do not stop the blade with your hand.
– Wear protective gloves.
– Keep the blade away from your feet.
1. In order to shut the engine down, first release the
drive bow (2) and then the engine brake lever (3).
Wait until the blade (27) stops.
2. Disconnect the spark plug connector (16) from the
spark plug (16a) to prevent the engine from restart-
ing.
11.6 Driving mode
The lawnmower is equipped with a rear-wheel drive.
11.6.1 Switching on the drive (Fig. 1)
1. Start the lawnmower (see11.4).
2. Pull and hold the drive bow (2) to the steering (1).
3. The drive is switched on (the drive wheel (21)
moves) and the lawnmower starts to move forwards
ATTENTION
Avoid damage to the product! Always actuate the
drive bow completely (until it reaches the stop) in or-
der to avoid subsequent damage to the transmission.
11.6.2 Switching off the product (Fig. 1)
1. Release the drive bow (2). The drive is switched off
and the lawnmower stops.
2. The engine continues to run.
11.7 After mowing
• Always allow the engine to cool down before park-
ing the lawnmower in an enclosed space. Remove
grass, leaves, grease, and oil before storage. Do
not store other objects on the lawnmower.
• Check all screws and nuts before the next use.
Tighten up loose screws.
• Empty the grass collection basket before the next
use.
• Please also observe the chapter “Storage”.
12 Cleaning
WARNING
Danger of injury and burning!
The product can start unexpectedly and cause inju-
ries.
– Switch off the motor before carrying out any
cleaning or maintenance work.
– Allow the motor to cool down.
– Disconnect the spark plug connector from the
spark plug.
WARNING
Health hazard!
Inhalation of fuel / lubricating oil vapours and exhaust
gases can cause serious damage to health, uncon-
sciousness and in extreme cases death.
– Do not breathe fuel / lubricating oil vapours and
exhaust gases.
– Operate the product outdoors only.
12.1 Cleaning the lawnmower (Fig.1)
• Cleaning with a garden hose is only recommended
at low pressure. A high-pressure cleaner is not suit-
able for cleaning the product.
• Unhook the grass collection basket and brush it out
with a hand brush. You can also roughly clean the
housing of the lawnmower with the sweeper.
• For larger soiling, you can wipe the product with a
damp cloth.
NOTE
Before tilting the lawnmower, empty the fuel tank fully
using a fuel extraction pump (not included in the
scope of delivery).
Do not tilt the lawnmower beyond 90 degrees.
38 | GB www.scheppach.com
To Next Page
Loading...
Need help?
General
