Scheppach Tiger 2500 Instruction Manual

 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB
|
25
16. Troubleshooting
Problem Possible cause Remedy
Engine does not
run.
Engine, cable or connector defective,
fuses burnt.
Have the machine checked by a specialist. Never repair
the engine yourself. Attention! Check the fuses and
replace them if necessary.
The engine starts
slowly and does not
reach the operating
speed.
Voltage too low, coils damaged,
capacitor burnt.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Engine producing
excessive noise.
Coils damaged, motor defective. Have the engine checked by a specialist.
Engine does not
reach full power.
Circuits in the network are overloaded
(lamps, other engines, etc.)
Do not use any other devices or engines on the same
circuit.
Motor overheats
easily.
󰀩
cooling of the engine.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum engine
cooling.

Scheppach Tiger 2500 Specifications

General

Input power	200 W
Power source	AC
AC input voltage	230 V
AC input frequency	50 Hz
Idle speed (max)	- RPM
Multi-tool applications	Grinding

Weight and Dimensions

Depth	320 mm
Width	325 mm
Height	335 mm