Maintenance
50 210.00 | PZN-plus | Assembly and Operating Manual | en | 389374
7 Maintenance
7.1 Notes
DANGER
Danger of explosion in potentially explosive areas!
l
Observe supplementary sheet for products with explosion-
resistant versions "PZN-plus -...-EX".
WARNING
Risk of burns through contact with hot surfaces!
Surfaces of components can heat up severely during operation.
Skin contact with hot surfaces causes severe burns to the skin.
l
For all work in the vicinity of hot surfaces, wear safety gloves.
l
Before carrying out any work, make sure that all surfaces
have cooled down to the ambient temperature.
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
Replacement of the housing and base jaws
The base jaws and the guides in the housing are matched to
each other. To replace these parts, send the product to SCHUNK
with a repair order.
Maintenance of version with gripping force maintenance I.D.
gripping and O.D. gripping
The pistons have to be aligned using an assembly device.
Therefore we recommend to have the module serviced and the
seals replaced by SCHUNK.
To Next Page
Loading...
Need help?
General
