Maintenance
10.00 | SRU | Assembly and Operating Manual | en | 389439
39
8 Maintenance
8.1 Notes
Original spare parts
Use only original spare parts of SCHUNK when replacing spare and
wear parts.
8.2 Maintenance interval
NOTICE
Material damage due to hardening lubricants!
Lubricants harden more quickly at temperatures above 60°C,
leading to possible product damage.
• Reduce the lubricant intervals accordingly.
Interval
(million cycles)
for SRU 8 - 14
Maintenance work
2 Clean all parts thoroughly, check for damage
and wear, if necessary replace seals and
wearing parts, Dismantle product [
}
40].
• Position of the wearing parts, Assembly
drawing [
}
42]
• Seal kit, Seal kit [
}
8]
2 Treat all grease areas with lubricant.
Oil or grease bare outside steel parts.
Lubricants/Lubrication points (basic
lubrication) [
}
40].
2 For H variant:
Check that the shock absorber is working, if
necessary replace the shock absorber,
Dismantle product [
}
40].
2 For S variant:
Check that the elastomer is working, if
necessary replace the elastomer, Dismantle
product [
}
40].
To Next Page
Loading...
Need help?
General
