SCHUNK STM 48V - Personnel Qualification; Safety-Conscious Working; Safety Measures During Transport; Safety Measures During Operation

Basic safety notes
05/STM-48V/en/2011-04-01/CW 13
2.5 Personnel qualification
2.5.1 Safety-conscious working
 Avoid any manner of working that may interfere with the
function and operational safety of the module.
 Observe the safety and accident-prevention regulations valid
at the usage site.
 Wear protective equipment.
2.5.2 Safety measures during transport
 When transporting and handling very heavy modules, take the
corresponding safety precautions.
 Make sure the cables have strain relief.
2.5.3 Safety measures during operation
 Only operate the module when all protective equipment has
been fitted and is in full working order.
 Check the module at least once per shift for externally visible
damage and faults.
 Report any changes including changes in operational
behaviour to the responsible place/persons immediately. If
necessary immediately shut down and lock out the
machine/system.
2.5.4 Behaviour in the event of faults or emergencies
If faults on the module occur which could impair safety or if the
operational performance indicates the occurrence of a fault:
 Shut down the machine/system immediately, lock it and report
the fault to the responsible place/persons.
 Faults may be eliminated by trained and authorized personnel
only.
 Only restart the machine/system when the cause of the fault
has been eliminated.