Start-up
32 05/STM-48V/en/2011-04-01/CW
8 Start-up
Malfunction in the event of an overload!
Avoid impact loads.
Do not exceed the bearing load limits.
Malfunction in the event of overheating!
Observe the motor’s technical data.
(see chapter 6.1, page 20)
Risk of injury and material damage when the
machine/system moves unexpectedly
Only allow configuration work to be carried out by authorized
specialist personnel.
Observe the information in the operating manual for the
controller.
Collisions in setup mode when the machine/system moves
unexpectedly
The motor could overspeed.
Keep the motor's moving range (360°) free.
Note
The SCHUNK controller MCS-12 is recommended for the opti-
mum use of the SCHUNK torque motor (STM). (see chapter 9
from page 34)
To Next Page
Loading...