Basic safety notes
14 05/STM-48V/en/2011-04-01/CW
2.6 Notes on particular risks
Risk of injury from objects falling and being ejected!
Provide protective equipment to prevent objects from falling or
being ejected, such as processed workpieces, tools, chips,
fragments, rejects.
Adapt the operating conditions, e.g. reduce the cycle time.
Risk of injury when the machine/system moves
unexpectedly!
Do not move parts by hand when the energy supply is
connected.
Do not reach into the open mechanism or the movement area
of the module.
Remove the energy supplies before installation, modification,
maintenance, or adjustment work.
Perform maintenance, modifications, and additions outside
the danger zone.
For all work, secure the module against accidental operation.
Risk of injury due to moving parts if these are controlled
incorrectly!
Possible causes for control errors:
• Incorrect cabling or wiring
• Removal of safety devices
• Software errors
• Sensor and signal transmitter errors
• Entry of incorrect parameters prior to start-up
• Defective module
To Next Page
Loading...