Basic safety notes
05/STM-48V/en/2011-04-01/CW 15
Risk of burns due to contact with hot surfaces!
During operation, the surface temperature of the STM may ex-
ceed +85°C (+185°F).
Allow the module to cool down to at least +40°C (+104°F)
before working on the module.
Measure the surface temperature before touching the module.
Wear protective gloves, if necessary.
Risk of electric shock due to contact with live parts!
Before conducting work on the machine and the auxiliary
equipment, disconnect them from the power supply and make
sure they cannot be accidentally switched back on again.
Wait until the frequency converter is discharged.
To Next Page
Loading...