SCHUNK SWS 150 - 5.4 Mechanical connection

Assembly
10.00 | SWS 005 – 300 | Assembly and Operating Manual | en | 389456
27
5.4 Mechanical connection
WARNING
Risk of injury when the machine/system moves unexpectedly!
Switch off power supply.
Evenness of the
mounting surface
The values apply to the whole mounting surface to which the
product is mounted.
Requirements for evenness of the mounting surface (Dimensions in mm)
Edge length Permissible unevenness
< 100 < 0.02
> 100 < 0.05
5.4.1 Fastening of the quick-change head (SWK)
Fastening of the quick-change head
For centering purposes, use the cylinder pin (2) out of the enclosed
pack.
You can fasten the quick-change head (SWK) with the screws (1).
mounting screws
Size screws (1) Quantity
005 M3 x 25 mm / DIN EN ISO 4762 4 *
007 M5 x 30 mm / DIN EN ISO 4762 4 *
011 M3 x 25 mm / DIN EN ISO 4762 4 *
011 HM M3 x 30 mm 12.9 / DIN EN ISO 4762 4 *
020 M4 x 30 mm / DIN EN ISO 10642 4 *
020 HM M4 x 30 mm / DIN EN ISO 4762 5 *
021 M4 x 35 mm / DIN EN ISO 10642 4 *
021 HM M4 x 30 mm 12.9 / DIN EN ISO 4762 6 *
022 M6 x 30 mm / DIN EN ISO 4762 4 *
027 M4 x 50 mm / DIN EN ISO 4762 6 *
040 M5 x 35 / DIN EN ISO 4762 6 *