Maintenance and Care
10.00 | SWS 005 – 300 | Assembly and Operating Manual | en | 389456
45
8 Maintenance and Care
WARNING
Risk of injury due to falling tool!
The tool can fall off during assembly, adjustment and
maintenance work.
• Only carry out assembly, adjustment and maintenance work
when the tool is placed in the storage rack or secured against
falling.
NOTE
The cleanliness of the work environment strongly influences the
error-free operation of the change system. If the work environ-
ment is prone to heavy contamination, it is very important that
the entire unit is protected from contamination with appropriate
measures.
Protective measures:
• Locate quick-change adapters at a distance from sources of
dust
• Include protective equipment in the storage rack (install
deflectors, air curtains or similar equipment on the unit)
Requirements of the storage magazine [
}
24]
NOTICE
Locking mechanism components are subject to corrosion from
water.
• If these components get wet, they must be dried and
regreased immediately.
• In wet or humid environments, inspect components and
regrease weekly.
8.1 Preventive Maintenance
The Tool Changer and optional modules are designed to provide a
long life with regular maintenance.
A visual inspection and preventive maintenance schedule is
provided in the table below depending upon the application.
Detailed assembly drawings, Assembly drawings [
}
62].
To Next Page
Loading...
