Page 43
7.4B RECTANGLE NOTCHER OPERATION
CAUTION: BEFORE OPERATING THIS TOOL, THE DOWNSTROKE OF THE MACHINE
MUST BE SET SO THAT THE FRONT OF THE TOP BLADE JUST PASSES THE LOWER
BLADES, (FAR ENOUGH SO THAT THE WIDE PART OF THE UPPER BLADE JUST
PASSES THE LOWER BLADES). FAILURE TO SET THE STROKE WILL RESULT IN
DAMAGE TO THE TOOL AND POSSIBLE INJURY TO THE OPERATOR. LUBRICATE
THE BLADES BEFORE THE FIRST CUT AND EVERY 10-15 CUTS, THEREAFTER. 3/8 OF
AN INCH (9.5MM) IS THE MAXIMUM MATERIAL THICKNESS THAT CAN BE SHEARED.
ALWAYS REMOVE THIS TOOL WHEN IT IS NOT IN USE.
FIGURE 17
To Next Page
Loading...
