Warning
Changes to the front panel of the MICS Telys
The MICS Telys front panel has been modified.
Leaving aside the colour and design of the keys, the modifications are as follows:
n the "I" key has been changed to the "I/P" key (output measurements)
o the "F/" key has been changed to the "F/H" key
p the "Manu" key has been changed to the "Start" key
previous design
new design
n The output measurement function will not be available initially, as software version 1.07G
will not be marketed until October 2003. Therefore, repeatedly pressing the "I/P" key will
only display the voltages.
o The change from the "F/" key to the "F/H" key does not affect the information displayed
on the screen.
p The most significant change is that from
the "Manu" key to the "Start" key. When the
generating set is started up in Manu mode, the
message shown opposite appears.
Fuel Lev(%)
E.Speed(RPM)
Batt.(Volts)
MANUAL mode selected
press MANU to confirm
24.2
50
0
As the "Manu" key is no longer present, one press on the "Start" key will trigger the starter
motor or the spark plug preheating (depending on configuration).
These modifications will be introduced to the technical documentation during
the next update (software update from version 1.06 F to version 1.07 G).
To Next Page
Loading...