 Spreading of waste water, sludge and waste is prohibited.
 The fuels to be used must correspond to those featured in the declaration file and the specifications recommended by the
combustion device manufacturer.
 The fuel is considered to remain in the same physical state as when it is introduced into the combustion chamber.
 Burning of waste in the open air is prohibited.
 Always protect your hands when checking for leaks. Pressurised liquids may penetrate body tissue and cause serious damage.
Risk of blood contamination.
 Drain and dispose of engine oil in a specially provided container (fuel distributors can collect your used oil).
 Except by special agreement, once closed, the gas supply main unit must only be re-opened by the gas distributor. However, the
user may access it under certain conditions. Check these for each site.
1.3.2 Risks related to exhaust gases and fuels
The carbon monoxide present in exhaust gases may cause death if the concentration levels in the air
breathed are too high.
Always use generating sets, pump units or lighting towers in a well-ventilated place where gases cannot
accumulate.
In case of indoor use:
 Be sure to evacuate exhaust gases outdoors.
 Provide appropriate ventilation so that personnel present are not affected.
Danger
 Observe the local regulations in force for generating sets, pump units or lighting towers, as well as local regulations for use of fuel
(petrol, diesel fuel and gas) before using your generating set, pump unit or lighting tower.
 Fuel filling should be carried out when the engine is off (except for generating sets with an automatic filling system).
 Engine exhaust gases are toxic: do not run the generating set, pump unit or lighting column in unventilated premises. If installed in
a ventilated room, additional requirements for fire and explosion protection must be observed.
 A leaking burnt gas exhaust may increase the sound level of the generating set, pump unit or lighting column. To check on its
efficiency, regularly examine the burnt gas exhaust.
 Pipes must be replaced as soon as their condition demands it.
1.3.3 Risks related to toxic products
The corrosion inhibitor contains alkali.
Do not swallow it.
This substance should not come into contact with the
eyes. In the event of contact with the eyes, rinse
immediately with plenty of water for at least 15
minutes.
Avoid prolonged or repeated contact with the skin. In
the event of contact with the skin, wash thoroughly
with water and soap. CONSULT A DOCTOR
IMMEDIATELY. KEEP THE PRODUCT OUT OF
THE REACH OF CHILDREN.
The anti-rust product is toxic and dangerous if
absorbed. Avoid all contact with the skin and eyes.
Read the instructions on the packaging.
Glycol is a toxic product and dangerous if absorbed.
Avoid all contact with the skin and eyes. Read the
instructions on the packaging.
Warning
 Caution: fuels and oils are dangerous to inhale. Ensure proper ventilation, and use a protective mask.
 Never expose the equipment to liquid splashes or rainfall, and do not place it on wet ground.
 The battery electrolyte is harmful to skin and especially eyes. If splashes get into eyes, rinse immediately with running water and/or
a 10% diluted boric acid solution.
 Wear protective eyewear and strong base resistant gloves for handling the electrolyte.
To Next Page
Loading...
Need help?
General
